Ver mas grande
CLIA Kit for Vitamin D2 (VD2)
CC-CCA921Ge
Producto nuevo
Comprando este producto generará 8 Biopuntos. Su cesta contiene un total 8 Biopuntos puede ser convertido en un Biobonos Descuento 32.00EUR.
Hoja técnica
| Size | 48T, <i>96T</i>, 96T×5, 96T×10, 96T×100 |
| Storage Conditions | -20°C |
| Shipping Conditions | Entre 4°C y 8°C |
| Applications | Chemiluminescent immunoassay for Antigen Detection. |
| Detection Range | 1.17-300ng/mL |
| Sensitivity | The minimum detectable dose of this kit is typically less than 0.45ng/mL |
| Research Area | Metabolic pathway |
| Organism species | Pan-species (General) |
| Alternative Names | Ergocalciferol |
| Item Name | Vitamin D2 |
| Assay Length | 2h |
| Method | Competitive Inhibition |
| Sample Type | Serum, plasma and other biological fluids |
| Formato | 48T, <i>96T</i>, 96T×5, 96T×10, 96T×100 |
| Test Principle | The microplate provided in this kit has been pre-coated with a monoclonal antibody specific to Vitamin D2 (VD2). A competitive inhibition reaction is launched between biotin labeled Vitamin D2 (VD2) and unlabeled Vitamin D2 (VD2) (Standards or samples) wi |
| Assay procedure summary | 1. Prepare all reagents, samples and standards |
| UniProt ID | - |
Más información
This assay has high sensitivity and excellent specificity for detection of Vitamin D2 (VD2).
No significant cross-reactivity or interference between Vitamin D2 (VD2) and analogues was observed.
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Vitamin D2 (VD2) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Vitamin D2 (VD2) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.